Using IntelliSwitch with Clicker 5 for Windows
by Penny McCulloch, August 2007
These instructions assume that you have already loaded your IntelliSwitch software.
- Plug in your IntelliSwitch receiver into your USB port
- Turn on your transmitter
- The IntelliSwitch Control Panel icon, located on your task bar, should now be blue
- Open Clicker 5
- While Clicker 5 is active, left click on the Control Panel icon
- The following menu will appear:
- Select Attach/Edit overlays for “Clicker 5”…
- The following window will appear:
- Make sure that Clicker 5 is selected in the applications list on the left hand side and then select Attach…
- An “Open” dialog box will appear as below.
- You need to navigate to the Sample folder. This can be found on the C: drive. Go to C:, then go to the folder “ITOOLS”, then to the folder “IntelliKeys USB”, then to the folder “private”, then to the folder “Application Overlays” and finally to the folder “Sample”. See the example below.
- Once you are in the Sample folder, select Clicker 5 Scan Overlay as below.
- Select Open.
- Select Done.
- You should now see a window pop open which says “Sending Clicker 5 Scan Overlay for Clicker 5 …”
If this window appears you are now able to use your IntelliSwitch. Simply make sure that Clicker 5 is setup for scanning.
- If this doesn’t appear, go to the IntelliSwitch Control Panel. The following menu should appear. Make sure that there is a check next to “send Clicker 5 Scan Overlay”
- The overlay should be sent and you can now use your IntelliSwitch. Simply make sure that Clicker 5 is setup for scanning.